FreeDVB

Hi, Anyone to help please, I am attached 4 satellite dishes via DiseqC
All the Ports of DiseqC are correctly configured but, At the time of scanning only one dish channels for all satellites

I suggest you remove the diseqc switch, scan the various satellite separately after that connect the diseqc and allocate the ports to the different satellites.

It is my advice to change port number as per satellite has to be connected

Hellobox8 wrote: ↑

Thu Aug 06, 2020 8:38 am

It is my advice to change port number as per satellite has to be connected

Dear Bro, Thanks but didnt work, It seems issue is with Board Components

Yawwilson wrote: ↑

Thu Aug 06, 2020 4:59 am

I suggest you remove the diseqc switch, scan the various satellite separately after that connect the diseqc and allocate the ports to the different satellites.

Dear Bro, Thanks but didnt work, It seems issue is with Board Components

Set as per diseqc switch port and set top port both are should be equal matched

myhellobox8 wrote: ↑

Wed Aug 05, 2020 9:05 pm

Hi, Anyone to help please, I am attached 4 satellite dishes via DiseqC
All the Ports of DiseqC are correctly configured but, At the time of scanning only one dish channels for all satellites

Do you have Diseqc working?
Here is an example video of how to check whether Disqc is working.
https://www.youtube.com/watch?v=Vh6AxlJfbxE
The video in Russian (everything can be understood and not knowing the language) describes in detail how Disqc will check. To check, you need a piece of cable with a connector and 2 components : any LED + 1 kΩ resistor (I would advise you to make 4 test cables with LEDs to immediately see which port is working)
https://www.youtube.com/watch?v=b0s09JkSWOg

What Disqc you configured in the settings - Disqc 1.0 or Disqc 1.1 ?
Disqc 1.0 is designed for 4-port Disqc or 2-port Disqc
Disqc 1.1 is designed for 8 port Disqc

DiseqC 1.0
1: 100.5E (5150-5750)
2: 166.0E (5150-5750)
Two ports are no problem. When using 100.E, if there is no signal from 166.E, the 100.5E cable must be disconnected. Can't switch anyway

myhellobox8 wrote: ↑

Fri Aug 14, 2020 3:08 pm

Yawwilson wrote: ↑

Thu Aug 06, 2020 4:59 am

I suggest you remove the diseqc switch, scan the various satellite separately after that connect the diseqc and allocate the ports to the different satellites.

Dear Bro, Thanks but didnt work, It seems issue is with Board Components

Well, bro I connect all 4 Lnbs to my diseqc and it works fine.. however if you want to scan with Dvbplayer, don't change the diseqc settings already allocated by the Hellobox 8..

See you tube how to configuration of disqc swtich