Hellobox 8 firmware release 202001027A

[juano82]

After I did this upgrade the Powervu is not working.

Well, if it's been working before the upgrade then, do a factory reset deleting all and do a fresh scan..

Thanks for the tip.

[Fredy]

Este firmware es oficial o no??

[Hello8123]

thanks

[Umufele Fele]

Thanks for this firmware..

[cankapendak]

What is "optimize standby time" mean? Mine is hellobox8 new version and updated with this s/w version but after turning off my hellobox8 to standby mode and wait for more than 10 minetes the red lamp on my bluetooth transmitter still light up (see on attached pic). Before I update my hellobox8 to this s/w version if I turn off my hellobox8 to standby mode the red lamp goes off. Please make some improvement on next s/w version. Thanks.

[edzus1]

What is "optimize standby time" mean? Mine is hellobox8 new version and updated with this s/w version but after turning off my hellobox8 to standby mode and wait for more than 10 minetes the red lamp on my bluetooth transmitter still light up (see on attached pic). Before I update my hellobox8 to this s/w version if I turn off my hellobox8 to standby mode the red lamp goes off. Please make some improvement on next s/w version. Thanks.

firmware update:

• Optimize standby time

• Fixed bug

Hellobox programmers i am amazed at your work with optimize standby time on this firmware 202001027A
The optimization of the time in the standby mode is made in such a way that the processor remains under full load all the time that the working mode and that the standby mode - is done in such a way that hellobox dies faster.


.......

It turns out that the October 20201027 firmware works correctly on Hellobox 8 OLD version, but the firmware does not work correctly on Hellobox 8 NEW version.

P.S.
It turns out the new firmware 20201027 - the firmware was tested only on Hellobox 8 OLD version, and with Hellobox 8 NEW the firmware version 20201027 was not tested.
......

[Myworld]

Ccam for 91.5e still not stable...please fix it

[Albert Cosmos G]

I just bought Hellobox 8 and updated the firmware but finds it difficult to active the Scam+
Please kindly educate me on how to active the Scam+. I have put it at ON, click on Register
but status shows "initialing" for about 15mins without any response. Please help

[fenddick]

I just bought Hellobox 8 and updated the firmware but finds it difficult to active the Scam+
Please kindly educate me on how to active the Scam+. I have put it at ON, click on Register
but status shows "initialing" for about 15mins without any response. Please help

Check your network,or you can use the DVBCam APP.

[EzKuTu]

Hellobox 8 firmware release 202001027A is valid for the NEW VERSION or only for the OLD