My device died after the update? new version (usb)

[formula]

My device died after the update, what should I do? The red bulb only works?
new version not old version (usb) !

[Jagosto]

I do have the same problem this recovery firmware ( auto_burn.fac) as been sento to me to try recovery but I have no luck

[formula]

Hi
1- please i want hellobox8.xml for winstbupgrader because it dmg.

error msg:
Aparse config file error!


2- please load hellobox8_upg in in another host:

https://drive.google.com/open?id=1ldPlZ ... aRLpji_V-M

i can't download it.

regards

[formula]

is this work like rs232 (usb ttl)

https://m.ar.aliexpress.com/api/stat/p4 ... .jpg_.webp

[sathex]

i can't download it.

1.jpg (72.9 KiB) Viewed 5652 times

is this work like rs232 (usb ttl)

do not wait and test, there is nothing to fear...

just refer to readme_download.jpg for hellobox8_upg usuage

[formula]

i can't download it.

1.jpg

is this work like rs232 (usb ttl)

do not wait and test, there is nothing to fear...

just refer to readme_download.jpg for hellobox8_upg usuage

thank you, but when i download it, my tablet save it:
Helobox8...... rar.mhtml

the size: 1.2 Mb

not the right rar file!


please upload it in mediafire.com

[sathex]

the size: 1.2 Mb

not the right rar file!


please upload it in mediafire.com

https://www.mediafire.com/file/gx292hii ... 0.rar/file

[formula]

the size: 1.2 Mb

not the right rar file!


please upload it in mediafire.com

https://www.mediafire.com/file/gx292hii ... 0.rar/file

thank you mr. sathex

after download, i used the program (Hellobox8_upg. exe), i got error msg:

serial port opened
reboot the stb manuallysync success
download start
change baudrate to 115200
sending boot init
send boot init completed

boot init run failed
m_download_thrd is stop!
m_sp__mnt_thrd is stop.

[sathex]

1st solution:
uses a former flash or dump of preference
Renow your flash in :
auto_burn.fac

of course with extention "fac" and not "bin"

Format your flash disk (FAT32)
Used it with the program (hellolox8_upg Exe) as described in the photos.

if don't work...
rename the upgrade sw file to flash.bin,and then storage it in the USB

...

2EM solution:
uses the same program but on upgrade
Do not forget about Click on "Erase All"
.....

finally if the problem persists you have to see if there is a hard problem
See also if there is an error in the procedure and configuration. ect.

Review what is described on this page in particular
the "auto upgrade" part
https://www.freedvb.com/viewtopic.php?f=25&t=14226
...

Note:
Personally I'm having fun with my receivers
By making transformations of all kinds...
And I have never had difficulties in their initial state!
so for you too
it sufits to find the right configuration.

Finally I think your problem comes from the procedure
because it is important to put the program in the root C: \
the program should work